If he is too busy doing other things this might have an impact on your print. But keep in mind, the Pi also sends the commands to the printer. ![]() You can use it to send you photos of the finished print or stream the whole print. Yes, you can attach a webcam or the Raspberry Pi cam to the Pi zero. This is why I would not make too much use of the streaming feature. The Pi Zero does not have as much compute power as the Pi 3. Or worse, if you short the GPIOs then you might even damage the Einst Rambo board. If not all pins have proper contact it will not work, your printer might noch even boot. So I recommend to touch something grounded before.Īlso be careful with the soldering. Be very careful touching the Pi with your hands, you might destroy the Pi with electrostatic charges. Manual Prusa MK3 Octoprint with Raspberry Pi Z WĪnd if you want to monitor and control your MK3 from your smartphone I recommend the Telegram plugin for Octoprint.īut one thing I will mention as a warning. I strongly recommend to follow this instructions from Prusa which are very good and also contain links to the Octoprint Image that is already prepared for the MK3, the Pi frame and the updated chassis for the electronics. I am using this one Thingiverse MK3 case for Pi ![]() You can find plenty on Thingiverse or use the one from Prusa. Then I would recommend printing a new case for the MK3 that allows you to get access to the Pi without the need to disassemble the whole printer every time. This is important as the "usual" ones are to short!Īnd maybe most important soldering equipment and skill!! The 3D printed frame, that is available from Prusa.Īnd a 18mm GPIO header dual male strip. So what you need is the Raspberry Pi Zero W(for WLAN) itself.Ī memory card, as priced dropped on black Friday and you never have enough I used a 16Gb card this time. ![]() I am using the Telegram bot plugin, to receive messages from my printer and send commands with my smart phone.Īnd because I like it so much I also want to have this on my cloned MK3. I have to admit that I used my original MK3 with the SD card for months until I did the Raspberry Pi Zero W upgrade. No external power source or cabling required. One thing I really love about my Prusa MK3 and especially about the Einsy Rambo board is the ability to stack a Raspberry Pi Zero W on that board.
0 Comments
Leave a Reply. |